Land Pool Restoration, Inc. | Overland Park, KS 66221 | Phone: (913) 894-4999 | E-mail: mailto:firstname.lastname@example.org
THE START-UP OF NEW PLASTER: There are several approaches to the initial start-up. The main objectives are to balance pH, total alkalinity and hardness levels, and to remove the plaster dust created by fresh plaster and water.
Quality, testable sequestering agents should be used to crystallize an un-filterable metallic contaminant and make it filterable. Failure to use this product can lead to staining and improper hydration of the plaster surface.
No automatic cleaners should be used for the first month. A roller-vacuum head may be used to vacuum the pool, taking care to not drag it sideways, and be sure to thoroughly brush the pool after vacuuming. The start-up procedure plays a critical role in the cosmetic appearance of the plaster surface in the years to come. Special brushing needs during the first month of new plaster are: Using a nylon pool brush, brush at least once daily during the first week, at least 4-5 times during the second week, 3-4 times during the third week and two to three times in the fourth week. If you have a chlorine generating system, no salt should be used in the pool for the first month. Pool pump should run continuously for the first thirty days. Pool heater should not be used for first thirty days.
TIPS TO HELP YOU THROUGH THE SEASONS: Your pool care will change depending upon the season of the year. You will find that during the summer, your chemical usage will increase due to evaporation, greater sunlight, increase in water temperature and pool usage. During periods of high winds, your plaster may need to be brushed more frequently to prevent dirt from adhering to the surface. In the rainy season, you may need to lower the water in your pool to maintain the proper level (halfway up the skimmer opening). Do not allow the pool to overflow.
As the owner of a newly plastered pool, you may have some questions about the care required to properly maintain the new surface. The following suggestions and pointers will help inform you about special areas of concern. Please remember that these are "generic" tips. For specific instructions it is always best to consult your contractor, plasterer or service professional.
FILLING YOUR POOL: A garden hose is placed in a fill pipe directed to the main drain grate in the deep end of the pool. The water must be left running until the pool is full and the water level is halfway up the skimmer opening. If more than one hose is used, additional hoses should be placed on the deck and weighted down so that the water will project into the deep end of the pool. Additional hoses should only be turned on once the pool contains 3-4 feet of water, with the volume adjusted so that the water does not contact plaster, only the center of the water in the deep end of the pool. Use care that water is not introduced in a manner that can damage plaster. Do not use the fill line to fill the pool. Do not fill the pool using softened water.